How to Make Stuffed Animals Fluffy Again

Download Article

Download Article

After being subjected to years of relentless hugging, squishing and being dragged through the dirt, your teddy bear volition harbour grime that it has accumulated over the years, will accept declining seams through which the stuffing is falling out, and won't be soft and cuddly anymore. Simply no teddy is set up for the trash; your teddy tin can probable exist rehabilitated and made ready for the next generation, as this 25 year old behave was.

Steps Download Commodity

1. 1

   If your deport does non already have a hole in a seam through which the stuffing can be removed, very carefully open up a direct seam (such as the back seam) by cutting the seam thread with a pair of scissors, a very sharp knife, or a seam ripper. Remove all of the stuffing and discard.^[1]

2. 

   ii

   Very gently hand-wash the now empty fur in warm water with a balmy laundry detergent. Rinse well with warm water. Repeat these steps every bit necessary, until the launder water no longer becomes coloured with the dirt that may come out of the fur. Gently squeeze (practice not wring) the fur to remove nearly of the water.^[2]

   Advertizement

3. 3

   Remove the excess water by placing an old towel on the floor, placing the behave on the towel, folding the towel over the behave, then standing on it. This will squeeze backlog water from the fur without wringing it, which could damage the fabric.^[3]

4. 

   iv

   Blow dry the carry with a accident dryer, being careful not to scorch the fur. Permit it to further air dry out overnight to ensure the seams are completely dry.

5. 5

   Tease out the disordered knots if the behave's fur was matted, after the carry is dry. A dental option works well. Piece of work the pick through the knots, being careful non to pull the fur out.

6. 

   6

   Plow the teddy bear inside out to examine each seam for holes and to examine the thread which may be, if the teddy acquit is very old, weak and rotten. Sew the holes airtight and reinforce the seams as needed, using either a needle and thread or a sewing automobile. If a needle and thread is used, be sure to place the stitches close together and pull each run up tight.^[four]

7. 7

   Turn the bear right side out. Examine the seams and areas you've stitched to ensure the seams are tight and the stitches are invisible from the outside. Tight seams are crucial!

8. 

   8

   Replace missing optics if necessary. Buttons work well.

9. 

   9

   Fill up each of the legs and arms using a ball of polyester fiberfill approximately 6 times the size of the book of the cavity to be filled, packing each very tightly. Using i ball for each arm and leg is better than filling them with many smaller assurance of fiberfill.^[five]

10. 10

    Fill up the caput and body cavity, using one big clump of fiberfill for each. Pack tightly, ensuring there is enough fiberfill to make the arm, leg and neck joints house.

11. 11

    Sew the seam closed that you lot've packed the fiberfill through.

12. 12

    Comb the fur to make it fluffy.

13. 

    13

    Dress your teddy in squeamish, make clean apparel, if you lot and (southward)he agree on it.

14. 14

    Take intendance of your newly refurbished teddy. Information technology'll exist good for decades to come up.

    Advertising

Add together New Question

• Question

  I take a new teddy conduct that has filling that sounds like it might exist hay or something coarse. How exercise I go about replacing the filling?

  

  You may be able to employ the filling from pillows. Alternatively, craft stores sell stuffing in large bags that would be suitable.

• Question

  How could I practise that to my teddy? He has feelings.

  

  Tell him he is going to hospital and has to have an operation and make it fun. After all, he will love his new look at the stop and then will y'all.

• Question

  Can I utilise this method if my teddy bear has a zipper?

  

  Yeah; because of the zipper, it will be easy to replace stuffing. Simply unzip information technology and take out the erstwhile stuffing, supervene upon with new stuffing and zip it back up.

• Question

  Where can I get filling?

  

  Virtually superstores and dollars stores comport it.

• Question

  Do you call up I volition need to do all that if I bought information technology at a austerity store?

  

  It depends how quondam the teddy conduct seems to exist. If it looks to exist in proficient condition, great! If y'all tin run across loose stitching and disordered fur, it might be time to refurbish.

• Question

  I have a teddy. She doesn't need to exist re-stuffed still, but her paws are filled with bean bag beans. The rest is stuffing. How would I get nigh this?

  

  swaggycooldragon

  Customs Answer

  You can put dried rice in the paws, or take some bean bag beans out of a bean purse.

• Question

  My teddy is fine, but its head is dangling slightly similar at that place is no stuffing in that area. What can I do about this?

  

  You could cutting the affect a seam and fill it with more stuffing in that surface area.

• Question

  If my teddy bear'southward fur is made out of very expensive material, should I still do this?

  

  It depends on how bad the bear'south condition is. If it has rips and tears, aye.

• Question

  What practice I do if the fur is very knotty?

  

  Dampen the fur and brush it lightly (if yous do information technology too hard, the fur might rip out), then look for information technology to dry out.

• Question

  My dog ripped the face off my collectible teddy bear. How tin can I fix this?

  

  If you still take the face, try to sew it back on. If not, you lot could use some fabric and button eyes. The teddy may not look perfect this way, but at least it'll have a face up.

See more than answers

Enquire a Question

200 characters left

Include your email accost to become a message when this question is answered.

Submit

Advertisement

• Use a heavy duty thread. Our example bear was stitched with a thread suitable for sewing denim.

• If your bear does not have a hole that needs to be repaired through which you can remove the stuffing, exist sure to make a pigsty just big enough to remove the stuff, as you lot will take to sew this hole closed when you are finished.

• When sewing with a needle and thread, use an overcasting stitch.

• Make sure yous put a generous amount of stuffing in your teddy or he/she might feel erstwhile and saggy.

• If your teddy feels a bit dusty or makes you coughing, gently tube vacuum information technology! It works groovy! Y'all could wipe him/her with a wet wipe if she/he is dirty.

Thanks for submitting a tip for review!

Advertisement

• Exercise not wring the water out of the fur! Doing so will impairment the fur.

• Employ caution when refurbishing a collectible teddy conduct -- it could lose its value.

• Don't overstuff your bear. This will crusade your teddy bear to be hard, not fluffy.

• Do not immerse a conduct with hardboard and metallic joints. The joints volition rot and/or rust. Surface wash it only!

• Use a thimble if sewing with a needle and thread.

Advertizement

Things You'll Need

• Heavy duty thread, in a colour like to the colour of the teddy bear
• A fine pick, such as the dental musical instrument illustrated
• Needle or sewing auto
• Pair of scissors
• Thimble (if sewing with a needle and thread)
• A bag of natural cotton or polyester fiberfill (approximately six times the size of the deport)
  • An culling to fiberfill stuffing is worn out panty hose. If y'all choose to apply this y'all won't demand to take the stuffing out of the bear next time you wash information technology. You will be able to motorcar wash and dry out it using gentle cycles.

Nigh This Article

Cheers to all authors for creating a page that has been read 175,703 times.

Did this article help you?

marshallsonfe1976.blogspot.com

Source: https://www.wikihow.com/Refurbish-a-Teddy-Bear

Share this post